Operating Instructions
3.17 Common Faults and Troubleshooting Methods of Tractor
3.17.1 Faults and Troubleshooting Methods of Chassis
3.17.1.1 Faults and Troubleshooting Methods of Clutch
Table 3-3 Faults and Troubleshooting Methods of Clutch
(1) There is oil stain on the friction plate and
pressure plate;
(2) The friction plate is excessively worn or
burnt out;
(3) The spring pressure decreases;
(4) The pedal free stroke is too short, or there is
no free stroke;
(5) The clutch driven plate is severely
deformed.
(1) Clean with gasoline, find out the cause and
troubleshoot.
(2) Replacement of friction plate
(3) Replace the spring
(4) Readjust the pedal free stroke as required.
(5) Replace the clutch driven plate
2. The clutch
is not
completely
disengaged,
and the gear
engagement
is noisy.
(1) The pedal free stroke is too long and the
working stroke is too short.
(2) The clutch driven plate is excessively
warped.
(3) Heads of 3 release levers not in the same
plane
(1) Adjust the pedal free stroke as required.
(2) Change the driven plate
(3) Adjust as required.
3. Trailer
jitters at start
(1) Heads of 3 release levers not in the same
plane
(2) Oil-stained friction plate and driven disc
(3) The driven plate is seriously warped.
(4) The fixing screws of flywheel and clutch
housing are loose.
(1) Adjust as required.
(2) Clean the friction plate and driven plate.
(3) Change the driven plate
(4) Stop immediately for inspection and
troubleshooting.
To Next Page
Loading...
