Appendix
Appendix 11
11.1 Oil and Solution for Tractor
Table 11-1 Oil and Solution for Tractor
Parts requiring
oil and solution
D-975 fuel recommended by American Society of Testing and Materials. Use 2-D grade oil at
normal temperature, and use 1-D grade oil when the temperature is lower than 5℃.
Lubricant oil viscosity of oil pan, fuel injection pump, governor oil and oil-bath air filter must
conform to SAE viscosity classification of American Society of Automotive Engineers, and
SAE10W shall be used below -5℃. SAE15W/40 multi-grade oil, which can be used
all-season, shall be used above -5℃. The quality level shall conform to API CD standard of
American Petroleum Institute.
Temperature above 4℃: clean soft water
Temperature below 4℃: antifreeze only
Minimum temperature above -15℃: -25# long-acting antifreeze (SH/T0521-1999)
Minimum temperature above -25℃: -35# long-acting antifreeze (SH/T0521-1999)
Minimum temperature above -35℃: -45# antifreeze (SH/T0521-1999)
Gearbox, rear
axle, hydraulic
lifting oil, front
drive axle,
steering gear
Transmission system, lifter, hydraulic steering, central and final transmission of front drive
axle adopt MF1135 or Ford M2C 86A of Massey Ferguson Company or dual-purpose oil
J20A of John Dill Company.
Adopt D-217 lubricant grease with viscosity grade 2 of American National Lubrication
Grease Institute (NLGI).
Important:
1. Transmission hydraulic dual-purpose oil, diesel oil and diesel engine oil must be precipitated for at least
48h before using, so as not to reduce the cleanness and affect the machine service performance;
2. It is strictly prohibited to mix oil of different grades and manufacturers! Avoid affecting engine
performance.
Note:
1. Never refuel while the diesel engine is running to avoid danger;
2. The fuel tank can't be filled up if the tractor works in the torrid weather, otherwise the fuel will overflow
due to expansion and cause an accident. And once it overflows, it should be wiped immediately.
To Next Page
Loading...
