Ignition Lock
Turn the preheat starting switch clockwise to ACC position to turn
on the auxiliary appliance, turn it clockwise to ON position to turn on the
control circuit,and turn clockwise to H position to turn on the preheating
device. After preheating, directly turn to ST position to start the engine.
Release the hand immediately after the engine starts, The key returns to
ON position automatically. The holding time in the starting position shall
not exceed 5s, otherwise, the starter will burn out.
Fig. 3-10 Ignition Lock
Warning: Before use, a careful and comprehensive inspection of tractors can eliminate
hidden dangers and effectively prevent accidents.
Before startup, carefully check whether the connections of each part are tight and reliable and that the
operating mechanism work normally. Check whether pipe joints of all parts are tightened and whether
there is oil leakage, water leakage or air leakage.
Check the lubricating oil level of engine oil sump, tractor transmission- rear axle and hydraulic system; the
radiator of water tank shall be filled with sufficient cooling water, and there shall be enough fuel in the
fuel tank.
Turn the fuel line switch handle of the fuel tank to the forward direction of the fuel pipe to make the fuel
line on;
Check the transmission control lever and power output shaft control handle, put the main gearshift lever
and power output
control handle and the front drive axle control handle in the neutral position, and put the distributor control
handle in the descending position;
Pull the shutdown cable locking device to loosen the shutdown cable. At this time, the fuel injection pump
is in fuel supply position;
Put the hand throttle in half-open state;
Confirm that the PTO rocker switch in the lower right position of the instrument panel is not connected;
Confirm that the handbrake is pulled up and the handbrake switch is in the free state (i.e. on-state);
To Next Page
Loading...
