EasyManua.ls Logo

Lovol TE Series - Engine Oil Inspection and Change; Maintenance of Fuel Filter; Technical Specifications; Main Technical Specifications

Lovol TE Series
121 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance Instructions
5.10 Inspection of Oil Quantity in Engine Oil Pan and Change of Oil
(1) Pull out the oil dipstick A at the front left of the oil pan
and check whether the oil level is between the upper and
lower scribed lines. If the oil level is lower than the lower
scribed line, add oil to the specified oil level.
Fig. 5-14 Inspection of Oil Quantity in Engine Oil
Pan
(2) Preheat the engine before maintenance and oil change.
After the oil temperature reaches 50 ~ 60, unscrew
the oil drain plug A under the oil pan, drain the dirty oil
and clean the pan, and then refill it with new oil.
Fig. 5-15 Oil Change of Engine Oil Pan
Important: It is forbidden to mix old and new oils and mix different brands of oils to avoid
damaging the engine. Replace the oil strictly according to the time specified in the Operation Manual of
Diesel Engine.
5.11 Maintenance of Fuel Filter
The fuel filter is located below the right side of the
engine. The paper filter element of the filter is not
allowed to be cleaned. Replace the filter element shall be
replaced every 200h of engine operation. The detailed
maintenance shall be carried out according to the
manufacturer's instructions.
Fig. 5-16 Maintenance of Fuel Filter
83

Table of Contents

Related product manuals