Lovol TE Series - Use of Front Drive Axle; Braking of Tractor

Operating Instructions
Important matters: during normal driving and turning of tractor, it is forbidden to use differential lock, so as not
to damage parts and accelerate wear of tires.
3.8 Use of front Drive Axle
LOVOL TE, ARBOS TE series wheeled tractors are appropriate for field heavy load operations or working
on wet and soft soil. If driven only by the rear wheels, the traction performance of the tractor may be
insufficient. At this time, the coupling of the front drive axle can increase the traction force of the tractor and
reduce the slip rate, thus improving the operation adaptability of the tractor. To facilitate engagement and
disengagement of the front drive axle, the following operating procedures shall be observed:
Coupling of front drive axle
Depress the main clutch pedal, shift the gear of the transmission, and then slowly release the clutch pedal.
When the tractor moves slightly, pull the front drive axle handle upward in time to change the two-wheel drive
into four-wheel drive.
Disconnection of the front drive axle
To disconnect the front drive axle, step on the main clutch pedal and push down the front drive axle
control handle to separate the front drive axle.
Important: The tractor is not allowed to engage the front drive axle during general transportation on hard road,
otherwise it will cause early wear of the front tires and increase fuel consumption. Only when the road surface
is slippery in rainy and snowy weather, and the rear wheels on the upper slope are easy to slip, can the front
drive axle be engaged. When the tractor leaves the difficult section, the front drive axle shall be disengaged;
3.9 Braking of Tractor
3.9.1 Braking of Tractor
 Under normal circumstances, the accelerator shall be reduced first, the clutch pedal shall be depressed, and
then the brake pedal shall be gradually depressed according to the situation to make the tractor stop
smoothly.
 During emergency stop, the clutch and brake pedal shall be depressed at the same time, and the brake
pedal shall not be depressed alone, so as to avoid rapid wear of brake friction plates or engine shutdown.
 To brake the trailer attached, adjust the length of the brake valve lever to brake the trailer before braking
the main engine.
29