unilateral brake to avoid the risk of rollover.
11. When the tractor is running on the road, it is necessary to pay attention to traffic signs and strictly abide
by traffic regulations to avoid accidental safety hazards.
12. During the transfer, the traffic rules must be strictly observed, and the driving distance between two
tractors shall be at least 60m, so as to avoid accident danger of collision.
13. Since the subgrade near the ditch, cave, embankment, etc. is fragile, the weight of the tractor may cause
it to collapse. Therefore, please drive around, otherwise, it may cause accidental danger.
14. The tractor shall not be overloaded or overused. Over-limit work is strictly prohibited, so as to prevent
the parts from being overloaded, resulting in damage to the machine or even personal casualty accidents.
15. When the tractor is working at night, it shall be equipped with good lighting equipment to avoid affecting
the working effect of the tractor and causing accidental danger.
16. When the tractor is engaged in harvesting or yard operation, a spark extinguishing device must be
installed on the exhaust pipe to avoid the risk of accidental fire.
17. When working on rainy and snowy days, it is necessary to reduce the operation speed, so as to avoid the
risk of rollover caused by slippery roads and ground.
18. During power output operation, reliable connection and protection must be ensured to avoid personal
injury caused by falling out of moving parts.
19. When coupling and towing machines and tools, it is necessary to ensure that each pin shaft is connected
reliably and firmly to avoid the risk of the collision caused by falling off of the pin shaft. When disconnecting and
towing machines and tools, it is necessary to ensure that all pin shafts are in a separate state to avoid damage to the
machine and personal safety caused by unclear separation.
20. During lifting, attention must be paid to the control of engine throttle to avoid damage to the machine and
personal safety caused by too fast lifting speed.
21. When charging the battery, make sure that the exhaust hole of the fluid injection plug is unblocked and
away from an open fire. Cut off the power supply first after charging to avoid an explosion.
22. The allowable safety height of high-voltage transmission lines shall be strictly observed to avoid the risk
of accidental danger.
23. Do not use tractors in areas where rollover may occur.
24. Prevent oil spillage when filling or cooling the engine or transmission after the tractor finishes its work.
25. No one shall stand around the suspension position when a three - point suspension mechanism is being
used.
26. The implement must be lowered to the ground before separating it from the tractor.
27. Users can adjust the PTO speed through the PTO operating device based on the functions of farm
implements and trailers. The PTO speed is 540/720 or 540/1000.
28. When the PTO drive shaft is to be used, the end cover of the PTO shaft must be removed to ensure that
the protective cover in the working area is installed correctly.
29. Under no circumstances shall the tractor be used when the tractor operation is at risk of overturning.
To Next Page
Loading...
