Operating Instructions
3.11.2 Removal and Installation of Tires
Tyre dismounting
Professional tire charger or professional manual tire mounting
equipment shall be used for tire removal and installation. Knocking and
beating with sharp and hard tools (such as screwdriver) and
sledgehammers is strictly prohibited, so as to avoid puncturing the tire or
damaging the bead and rim.
During removal of the tire, deflate the tire first, and then push the
bead toe away from the rim edge with a special tool, and then use the
cup grease to lubricate the bead toe and rim edge fully, and finally use
professional equipment to remove the tire. The removal process ends.
Non-compliance and brutal operation of any kind is strictly
prohibited.
Manual Removal Equipment
Installation of tires
Before installation, fully lubricate the bead toe and rim
with the cup grease used for fitting of tires;
In order to ensure that the bead toe can fall correctly on
the rim bead seat, the inflation pressure can be
appropriately raised during inflation (but not greater
than 0.25MPa), and adjusted to 0.16MPa after the bead
seat is fully in position;
Finally, check whether the position of the valve
is skewed and whether the tire bead and rim are
closely attached, and whether the ring fits
tightly with the bead.
To Next Page
Loading...
