Lovol TE Series - Page 76

Operating Instructions
3.17.2.5 Faults and Troubleshooting Methods of Lighting
Table 3-14 Faults and Troubleshooting Methods of Lighting
S/N
Fault
symptom
Failure cause
Troubleshooting methods
1
Headlamp
without
high-and-low
beam
(1) The circuit is open; and the
short-circuit fuse is blown.
(2) The dimmer switch is in poor contact
and damaged.
(3) Filament is burnt
(1) Repair and close the circuit.
(2) Overhaul and replacement
(3) Replace with the bulb of good quality.
2
The rear lamp
is not on.
(1) Open circuit
(2) The rear lamp switch is in poor
contact and damaged.
(1) Repair and close the circuit.
(2) Overhaul or replacement
66