Chapter 7 Built-in High-speed Counter Function
XBC E-Type Main Unit 7-13 Ver. 1
iii. In order to make actual comparison enabled after compared output condition is
set, the compared enable signal must be On.
Classification
Operation
Compared enable signal K2604 K2704 K2804 K2904 0: disable, 1: enable
I. In order to make external output, the compared equivalent output signal
(P20~P27) must be set. If Compared output contact is Off, Compared
coincidence output signal (internal device) is only output.
Classification
Operation
Compared equivalent
output signal
K2612 K2712 K2812 K2912
equivalent
1: Compared output
II. Compared output point (P40 ~ P43) setting
To Next Page
Loading...
