Chapter 5 Programming Concepts
XBC E-Type Main Unit 5-17 Ver. 1
5.2.2 STOP mode
Stop state without Program operation. It is available to transmit the program through XG5000 only in Remote
STOP mode.
1. Processing at Mode Change:
Clear the output image area and execute output update.
2. Operation Processing Contents
a. Executes I/O update.
b. Checks for normal operation or missing built-in module.
c. Communication service or other internal processing.
5.2.3 Change operation mode
1. Operation Mode Change Method
The methods to change operation mode are as follows.
a. By mode switch of CPU module inside communication port door.
b. By connecting the programming software (XG5000) to communication port of CPU
c. By changing the operation mode of other CPU module connected to network by
XG5000 connected to communication port of CPU.
d. By using XG5000, HMI, computer link module connected to network
e. By ‘STOP‘ instruction during program execution
2. Type of operation mode
The operation mode setting is as follows.
Operation mode switch XG5000 command Operation mode
RUN unchangeable Local Run
STOP
RUN Remote Run
STOP Remote Stop
Debug Debug Run
Mode change Previous operation mode
RUN -> STOP - Stop
To Next Page
Loading...
