LS Industrial Systems XBC-E Series - Main Unit Digital I;O Specifications; General I;O Specifications

Chapter 3 Installation and Wiring
XBC E-Type Main Unit 3-23 Ver. 1
3.7 Main Unit Digital I/O Specifications
3.7.1 General I/O Specifications
General Specifications
Cable and Terminals 26 - 16 AWG (0.14 - 1.5 mm
2
); Cu wire; Terminal block (M3 X 6 screw)
Torque 5.2 in/lb (0.58 N/m)
Input Side Terminals (Top)
RX RS232C Receive Data
TX RS232C Transmit Data
SG RS232C Signal Ground
485+ RS485+ Data
485- RS485- Data
Pxx Input Points P00 - Pxx (Depending on PLC I/O Count)
COM Input Point Common
Output Side Terminals (Bottom)
L 100-240VAC Line In
N 100-240VAC Neutral
PE 100-240VAC Ground
Pxx Output Points P40 - Pxx (Depending on PLC I/O Count)
COMx Output Points Common COM0 – COMx (Depending on PLC I/O Count)
P Photocoupler 12-24VDC Positive Power Input (Depending on Output)
N Photocoupler 12-24VDC Negative Power Input (Depending on Output)
24V 24VDC Positive Power Output
24G 24VDC Negative Power Output