Chapter 2 Quick Start Guide
XBC E-Type Main Unit 2-7 Ver. 1
2.4 Installation and Wiring of PLC
2.4.1 Connect Power Wiring
1. We are going to wire PLC and test program using PLC hardware.
a. Connect power and I/O wiring to PLC according to the drawing below.
b. The Test Switch will be wired to input P00 using power from the on-board 24VDC
supply.
c. The Test Lamp will be wired to output P40 sharing power from our 120VAC source.
d. In this example, XBC-DR10E model will be used. For more details see Chapter 3:
Installation and Wiring.
To Next Page
Loading...
