LS Industrial Systems XBC-E Series - 3.6 Wiring Guidelines

Chapter 3 Installation and Wiring
XBC E-Type Main Unit 3-15 Ver. 1
For equipment installed next to PLC: 2in. (50mm) or more
3.6 Wiring Guidelines
Minimum 2in.
(50mm)
Minimum 2in.
(50mm)
Warning
 When wiring, disconnect the external power.
 If all external power is not disconnected, electrical shock or equipment damage may occur.
 Always use terminal cover included with product. If not, electrical show may occur.
Caution
 Use D type ground (type 3 ground) or above dedicated for PLC for PE and LG terminal. Improper
grounding may cause electric shock or malfunction.
 When wiring module, check the rated voltage and terminal array. Incorrect wiring may cause fire or
malfunction.
 For external connector, use proper wiring techniques.
 Use designated torque range for screws. Terminal damage or loose electrical connection may
occur.
 Do not allow foreign material to enter module. Module damage or system malfunction may occur.