61
3) Saving and monitoring of failure history
Previous failures are saved in Trip Mode. Up to 5 failures can be saved.
Failure history is saved not only by Reset but also in case of a low voltage failure due to
being switched off.
If the number of failures exceeds 5, the preceding 5 messages are automatically deleted.
- In case of a failure during operation, the
mode automatically shifts to Trip Mode with the
trip displayed.
- If you press Reset or the terminal is entered,
the failure above is reset, the above failure is
automatically save. The previous drive status is
then restored.
- Move to Trip Mode using Mode key.
- The most recent failure is saved in Last-1
code.
- Press Right key.
- A previous failure is saved in Last-2 code.
- If another failure occurs, what was in Last-2
moves to Last-3.
To Next Page
Loading...
