LSIS XGL-EFMT - Configuration of P2 P Parameters

Chapter 7 P2P Service
7-2
7.1.2 Configuration of P2P parameters
In order to use P2P service the user needs to execute setting for the operation desired on the
P2P parameters window. Specify type, base and slot as desired on the P2P screen to display
P2P parameters setting screen composed of 4 kinds of information as shown in the figure below;
[Fig. 7.1.2] P2P parameters module setting
[Fig. 7.1.3] Setting and registration screen of P2P parameters
(1) P2P channel
 Logical channel of P2P Service (IP, PORT, dedicated driver) to be executed can be setup.
 User defined frame, XGT client and MODBUS TCP client setting available.
 Communication device setting available which uses other protocol than XGT/MODBUS TCP.
(2) P2P block
 64 P2P blocks setting separately operated.
(3) Define user frame
 Registration of user defined frames.
(4) E-mail
 Frame registration to transmit and receive e-mail frames.