LSIS XGL-EFMT - System Configuration Using Dedicated Ethernet between Hmis, Plcs at XGR System

Chapter 4 System Configuration
4-5
4.1.6 System configuration using dedicated Ethernet between HMIs, PLCs at
XGR system
At XGR system, Ethernet module should be installed at main base and same slot of A/B bases.
Ethernet module installed at base acting as MASTER executes the communication service but
Ethernet module installed at base acting as STANDBY CPU doesn’t execute the
communication service.
Ethernet
(Network [2])
A-Side
IP: 192.168.91.191
XGK/I PLC
IP: 192.168.91.192
IP: 192.168.91.192
Upper system
IP: 192.168.91.193
Upper system
IP: 192.168.91.193
GLOFA
VIEW
GLOFA
VIEW
Ethernet
(Network [1])
B-Side
IP: 192.168.91.191
XGR
[Figure 4.1.6] XGT Ethernet redundancy system (Redundant Network)
A-Side
IP: 192.168.91.191
XGK/I PLC
IP: 192.168.91.193
Upper system
IP: 192.168.91.194
GLOFA
VIEW
Ehternet
B-Side
IP: 192.168.91.192
XGR
[Figure 4.1.7] Communication as XGT redundant system (Single network)