Chapter 9 Remote Connection Service
9-8
9.2.3 Remote 1 connection directly from PC connected with Ethernet
Remote stage 1 connection via Ethernet without connecting RS-232C is available if a PC where
XG5000 is operating is included in PLC Ethernet network.
[Fig. 9.2.5] Remote stage 1 connection system through PC
[Fig. 9.2.5] shows the connection between PC and PLC via Ethernet, where connection to
all PLCs on the network is available without RS-232C used in XG5000. In this case local
connection is omissible and remote 1 connection is available with all PLCs.
Select āConnection settingsā on the Online menu and change the setting in the dialog box as
specified below to establish remote stage 1 connection directly via Ethernet.
[Fig. 9.2.6] Remote 1 connection directly via Ethernet
To Next Page
Loading...
