Chapter 5 XG5000 Program
5-24
5.5.2 Enable Link
Link enable procedures are necessary to start the operation of the communication for actual
Tx/Rx of downloaded High-speed link and P2P data through XG5000. Let Link Enable ON to
start Tx/Rx service of the communication module, which will enable or disenable the operation
relationship separately from the specified parameters, where the communication will be kept on
based on the Enable conditions even if CPU stops.
(1) Link Enable from XG5000
The next is to specify XG5000 for the Enable conditions. Click the setting menu on [Fig. 5.5.6] to
display [Fig. 5.5.7]. Check the items which need the link service.
[Fig. 5.5.6] Enable Link setting
To Next Page
Loading...
