Chapter 9 Remote Connection Service
9-9
(1) Connection type
Select an applicable type for connection. In the case of [Fig. 9.2.6], select Ethernet because
the connection is established directly via Ethernet without application of RS-232C.
(2) Connection depth
Decide a PLC connection stage of remote stage 1 or 2. Select remote 1 here.
(3) IP address
Set the IP address of FEnet I/F module to connect to. Use IP address, 210.206.91.190 to
connect to PLC [n] in [Fig. 9.2.6].
The rest procedures are the same as with RS-232C used. Now click [OK] and then select
[Connect] on the Online menu.
It is accessible through Ethernet which the CPU module direct connection without Ethernet I/F
module. CPU direct connection support high performance XGT-series.
(High performance XGT: Ethernet port internal CPU)
To Next Page
Loading...
