Chapter 9 Remote Connection Service
9-7
Remote 2 only will be described below since the others are the same in the dialog box above.
(1) Setting of network type
Select a network type for remote stage 2 connection among XGT Rnet, Fdnet, Cnet, FEnet
and FDEnet. Network types of stage 1 and stage 2 connections bear no relation to each
other. XGL-FEnet is to be selected since stage 2 connection is with FEnet in [Fig. 9.2.4].
(2) IP address
Specify the IP address of FEnet I/F module installed in the PLC [B] which will be connected
with XG5000 in the network 2. Use the IP address of FEnet module installed in PLC [B]
station, 192.168.91.192
in [Fig. 9.2.4].
(3) Base and slot No.
Set the Base and Slot No. where FEnet module is installed in the PLC [2] which will be
connected with stage 2 in the network 2.
Stage 2 connection-completed status as above is the logical connection status identical to the
connection with RS-232C cable is connected to PLC [B], where all of the on-line menus are
available.
To Next Page
Loading...
