Chapter 7 P2P Service
7-17
(2) P2P service start
Even after P2P parameters are downloaded, P2P shall be started in order to start the P2P
service. Select [Online] -> [Communication module setting] -> [Enable Link] (HS link, P2P)] on
the menu.
[Fig. 7.4.2] Enable setting of P2P service
Select P2P parameters to start on the [Enable Link (HS link, P2P)] window. The P2P parameters
already checked is during run, whose P2P service will stop if cancelled.
In order to confirm normal downloading and normal P2P service operation, select [System
Diagnosis] on the menu.
To Next Page
Loading...
