LSIS XGL-EFMT - Page 29

Chapter 2 Product Specifications
2-7
LED
내 용
RUN
Indicates whether initialization is done successfully and it works properly. In case
initialization is done successfully, LED is on. In case initialization is not normal or
done abnormally, LED is off.
HS
Indicates whether High speed link service is normal or not. In case HS link setting is
done, service is enabled and service is executed normally, LED is on.
Though the user sets the HS link, if the user doesn’t enable the HS link service,
service is not executed.
P2P
Indicates whether P2P service is normal or not. In case P2P setting is done, P2P
service is enabled and service is executed normally, LED is on.
Though the user sets the P2P, if the user doesn’t enable the P2P service, service is
not executed.
PADT
Indicates whether PADT is connected or not through FEnet I/F module. If PADT is
connected, LED is on. If not, LED is off.
SVR
Indicate whether connection with remote Ethernet interface communication
device(include PC) and dedicated communication service. In case dedicated
communication is used, LED is on.
ERR
Indicates hardware error. It means heavy error so if this LED is on, contact custom
service center.
RELAY
Indicate whether use frame relay function between Port1 and Port2. In case relay
function setting is done, LED is on. In case relay function is not set, LED is off.
CHK
In case IP collision, high-speed link station number collision or there is difference
between set media type and actual media type, LED is flickering. In case normal
operating, LED is off.
FAULT
In case there are communication frame error(CRC error or others), LED is on. In
case normal operating, LED is off.
ACT
In case Ethernet I/F module send and receive data, LED is on. In case send and stop
send operations are repeat, LED is flickering.
LNK In case Ethernet I/F module connect link with network, LED is on
[Table 2.3.2 LEDs of XGL-EFMTB/EFMFB module]