LSIS XGL-EFMT - Page 54

Chapter 5 XG5000 Program
5-5
c) [Communication module settings] -> select module type, base, slot
[Fig. 5.2.6] Communication module setting
FEnet module is registered on Slot 2 of Base 0 is as shown below;
[Fig. 5.2.7] Manually register communication module
B) Register in Online status.
If Connect XG5000 and PLC on which the communication module is installed, I/O sync can
help automatically register module.
a) Select [Online] -> [Diagnosis] -> [I/O information]