LSIS XGL-EFMT - Page 69

Chapter 5 XG5000 Program
5-20
[Fig. 5.4.3] Selection of communication module
Classification
Description
Communication
module settings
Module type Select FEnet.
Base No.
Select Base No. the module is installed on.
(Main Base : 00)
Slot No. Select Slot No. the module is installed on.
[Fig. 5.4.4] P2P setting details
After communication module setting is completed, P2P setting details screen will be displayed as
in [Fig. 5.4.3]. Refer to Chapter 7 P2P Service for detailed setting.
Classification
Description
P2P
channel
User defined frame
Edit the user defined protocol.
XGT client
Set dedicated service master.
Modbus TCP client
Set to Modbus TCP master.
P2P Block
Set each command block based on specified XGT client
of P2P channel.
User defined frame
Set each command frame for the user defined frame of
P2P channel.
E-mail
Execute as defined by the user for E-mail service.