Chapter 6 High-speed Link Service
6-8
Output data
setup in case of
emergency
Latch
Maintain and send the latest data received from CPU. It is seen that
it is cleared if CPU sends data as 0 even though latch is set. Make
sure to check the emergency output data setting of CPU.
It sends by setting received High-speed Link data as 0 in ignoring
data from CPU. If emergency data is set as ‘clear’ in emergency
output data setting of XG5000 High-speed Link module setting even
though emergency output data setting of device area of High-speed
Link sending part is set as latch in CPU, the data set as 0 is sent.
Make sure to set it after checking desired operation.
[Table 6.4.2] Setting of communication module and communication period
(3) High-speed link parameters settings
Click [OK] on [Fig.6.4.4] screen to display [Fig.6.4.5] of ‘HS link block registration’ window.
[Fig. 6.4.5] HS link block registration screen.
To Next Page
Loading...
