PARTNER II System Programming
Programming Automated Attendant
This section presents the procedures required to program the PARTNER II Release
3 for use with PARTNER MAIL Automated Attendant Service.
Assign VMS Hunt Delay (#506)
Set the delay for either Immediate or Delayed Call Handling.
1.
2.
3.
4.
5.
Locate “VMS Hunt Delay” on PARTNER II Form A.
Access System Programming as described in “Accessing System
Programming” and press [
#
] [
5
] [
0
] [
6
].
If “Immediate Call Handling” is checked (the factory setting for Automated
Attendant Service) press
[
Next Data
]
until the display reads:
1 Immediate.
If “Delayed Call Handling” is checked press [ Next Data ] until the display reads:
2 Delayed.
Choose:
— Press [ #
] and a system program number to program another feature, or
—
Press
[
Next Procedure
]
or
[
Prev Procedure
]
to program another feature, or
—
Press
[
Feature
]
[
0
] [
0
] to exit programming.
Assign the VMS Hunt Schedule (#507)
Specify when the Automated Attendant Service handles calls.
1.
Locate “VMS Hunt Schedule” on PARTNER II Form A.
2.
Access System Programming as described in “Accessing System
Programming” and press [
#
] [
5
] [
0
] [
7
].
3
If:
the customer checked “Always” (the factory setting), press
[ Next Data ]
—
until
1 Always
is displayed.
—
the customer checked “Day only”, press
[
Next Data
]
until
2 Day Only
is
displayed.
—
the customer checked “Night only”, press
[ Next Data ] until 3 Night
Only
is displayed.
3-8 Programming Automated Attendant
To Next Page
Loading...
Need help?
General