PARTNER MAIL - Initial Programming
Programming the Fax Extension
Assign the Fax extension, or the Fax Hunt Group, where the Automated Attendant
Service transfers fax calls.
■
■
1.
2.
3.
4.
5.
Use Form 2: System Parameters to identify the fax extension or Fax Hunt
Group.
When you program the system to transfer fax messages, the Touch-Tone
Gate is set ON automatically. This enables the system to immediately detect
fax transmissions and send them to a fax machine.
Access the Administration Main Menu as described in an earlier section.
The system plays the system programming options.
Press [
1
] to program System Parameters.
Press [
4
] to program the fax extension.
Enter the Fax extension or Fax Hunt Group extension followed by [ # ]. The
system confirms the new fax extension and plays,
The touch-tone gate is on.
NOTE:
To deactivate fax call handling, enter [ 0
] as the fax extension, then
press [
#
].
Press [
✱
] [
#
] to return to the System Administration Menu.
4-12 Programming System Parameters
To Next Page
Loading...
Need help?
General