Page 12 of 60
free, without corrosive or combustible gas, or extreme temperature or humidity.
Carefully unpack all the components of the colposcope and check it with the packing list. Ensure that all
components are present and in good working order.
When using the colposcope with a monitor, keep a space of at least 5cm between the monitor and the wall
to ensure good air ventilation.
When using the colposcope with a computer system, please reference the minimum requirements below.
Minimum computer requirements:
• Type: PC
• CPU dual-core above 2.4GHz CPU
• Internal storage at least 4G
• Hard disk space of 200 GB or more
• Motherboard with PCI-E slot, HD products should have HDMI interface.
• Monitor: with wall-mount Dimension
• SD: not less than 1920×1080 dpi; 1080P, with HDMI interface
• HD: not less than 1920 x 1080 dpi; 1080P, with HDMI interface
• USB3.0 high speed interface
• Operating System: WINDOWS 7 or WINDOWS 10
Please keep the room clean and avoid static discharge directed at the unit, noise interference, and direct
sun. Extreme temperature can affect the accuracy of the monitor and damage accessories or circuits.
When the device is transported from one location to the next, please take note of the environment. Water
condensation might result due to exposure to humidity and temperature difference. Please ensure that there
is no water condensing in the device before use.
Operating rooms should be ventilated, and protected from static discharge, noise interference, and strong
power surges.
To ensure safety during use, the user must use proper grounding for the colposcope, especially when used
together with any microwave machine or high frequency device.
1.5 Unpacking and Inspecting
Make sure the proper side is facing up when opening the box by following the markings on the packaging.
After unpacking the camera and accessories, keep the packing materials properly stored for return service if
necessary. Keep packing material away from children.
Carefully check the device and the accessories against the packing list supplied by the manufacturer and
see if there is anything missing or damaged. If anything is damaged or missing, please contact the
manufacturer or distributor immediately.
Disposal of packaging material should be done according to local waste disposal rules.
1.6 Additional Information
This manual explains the performance, operation and maintenance of the system. If schematic diagrams,
key component lists or any other materials are needed by an authorized technician, please contact the
manufacturer.
NOTE: This manual should be placed near the device for easy user reference. Read the manual thoroughly
before using the device to ensure proper operation and safety.
To Next Page
Loading...
