The remote might be
damaged.
If the camera buttons work,
then the problem may be
the remote. Please contact
Lutech’s service center.
The vertical stand is not
moving well.
The caster (wheel) locks
may be engaged.
Check to see if the locking
mechanism on the casters
are down. If it is, lift up to
disengage the lock. All 4
casters have locks so make
sure all 4 are disengaged.
For any questions or concerns, please contact the manufacturer or authorized repair/service center.
WARNING:
• Always disconnect the colposcope from any power source before disassembling any components or parts.
• The colposcope should always be operated by trained and authorized personnel and according to the
requirements of the Operator’s Manual.
To Next Page
Loading...
