227
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
Group Config
Write View:
Select the View to be the active Write View. Management Access Is set to
write only, changes can be made to the assigned SNMP View Config. A
View defined both as the Read View and the Write View can be Read
and/or Modified.
Notify View:
Select the View to be the active Notify View. The Management Station can
receive Trap Messages from the assigned SNMP View Config. Trap Messages
are generated by the Switch’s SNMP Agent.
Group Table
Select:
Select the desired entry(ies) to Delete the corresponding Group.
Group Name:
Displays the Group Name.
Security Model:
Displays the Security Model of the Group.
Security Level:
Displays the Security Level of the Group.
Read View:
Displays the Read View Name in the Entry.
Write View:
Displays the Write View Name in the Entry.
Notify View:
Displays the Notify View Name in the Entry.
Operation:
Click the Edit button to modify the View settings in the Entry, then click the
Modify button to apply.
CAUTION: SNMP Group Settings will be restored to defaults if the Switch
is restarted and you have not selected Save Config from the
main menu and saved your running configuration to non-
volatile memory.
NOTE: Every Group must contain at least a Read View. The default Read
View is viewDefault.
13.1.4 SNMP User Config
The User in an SNMP Group can Manage the Switch via the Management Station. The
User and its Group have the same Security Level and Access Rights. You can configure
the SNMP User Config on this page.
To Next Page
Loading...
