281
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
The following entries are displayed on this screen:
Loopback Type
Internal:
Select Internal to test whether the Port is available.
External:
Select External to test whether the Device connected to the Port of the
Switch is available
Loopback Port
Loopback Port:
Select the desired Port for Loopback testing.
Test:
Click the Test button to start the Loopback test on the Port.
16.4 Network Diagnostics
This Switch provides Ping and Trace Route test functions for Network diagnostics.
16.4.1 Ping
The Ping test function tests the connectivity between the Switch and a node of the
Network. This helps test Network connectivity.
Choose the menu Maintenance>>Network Diagnostics>>Ping to load the
following page:
Figure 16-9 Ping The following entries are displayed on this screen:
Ping Confi g
Destination IP:
Enter the IP Address of the Destination node for Ping testing.
Ping Times:
Enter the number of times to send test Data during Ping testing. The
default value is recommended in most cases.
Data Size:
Enter the Size of the sent Data during Ping testing. The default value
is recommended.
Interval:
Specify the Interval to send ICMP request packets. The default value
is recommended.
16.4.2 Trace Route
The Trace Route test function is used to test the connectivity of gateways during the
packets journey from the Source to Destination of the test Data.
To Next Page
Loading...
Need help?
General
