LX160
21.09.06
Page 13
8.5. RES (altitude reserve)
In this menu we are setting the altitude reserve. If the altitude reserve will be 200m, that
means, the final glide will be calculated 200m above the target point.
Figure 12 Altitude reserve
8.6. GPS
In this menu we enable or disable receiving of NMEA sentences from a GPS device. Default is
NMEA receiving is enabled. If we want to correct some calculated parameter (distance, wind
component), we must first disable NMEA, because if NMEA is enabled a GPS data is valid, we
are not able to change these two parameters. When we disable receiving of NMEA both
parameter values remain. Receiving of the NMEA can be enabled back at any time. If the GPS
device is not connected on the LX160, or the GPS data is not valid, this menu has no use.
(GPGGA, GPRMC, GPRMB)
Figure 13 NMEA is disabled,
NMEA data isn't detected
Figure 14 NMEA is disabled,
NMEA data is detected
Figure 15 GPS data valid
Figure 16 GPS data isn't
valid
To Next Page
Loading...
Need help?
General
