4. Connect the wires to the terminal,
referring to the chart inside the
base for the proper connections.
5. Before replacing the cover, make sure that you
have made any necessary modification to DIP
switch or jumper settings (see “Jumper Settings”).
Electronic controls are static sensitive devices; discharge yourself properly before manipulating and installing the device.
Short circuits or incorrect wiring may permanently damage the controller. Double check your wiring before applying power.
If a control failure could lead to personal injury and/or loss of property, the installer must add safety devices and/or alarm
systems to protect against failures.
Installation
BW437-RTU-LX Mounting Instructions
www.lynxspring.com
To Next Page
Loading...
