MA lighting Lightcommander 12/2 - Important Button Keys; Delete All; Lock Preset Mode; Lock Programming

Lightcommander Lightcommander
Lightcommander Lightcommander
Lightcommander
11
11
1
2/22/2
2/22/2
2/2
eMail: info@malighting.de
.
Tel.: +49 931 497940
.
User's Manual Lightcommander 12/2
2727
2727
27
Important Button Keys
Deleting the entire stored programs (Delete All)
Freezing the Two Presets Mode (Lock Preset Mode)
Programming disabled (Lock Programming)
Indicating the Chase storage (Blank Chase Storage indication)
Indicating the Software Version (Software Version)
These following five functions are available, if the desk is
turned off and the respective buttons are pressed and
held down, while turning on the desk again.
Î Observe the display and hold the buttons until the menu
is displayed!
Delete All
Î Press and hold Soft A + Soft B + Quit.
Î YES deletes all Memories and Chasers.
Presettings will be set to Standard.
(Patch: 1 :1; Solo: All Enabled; Curve: All Linear)
Lock Preset Mode
Î Press and hold Hold + Live + Upper.
Î YES activates the Preset Mode and locks Page.
Undo: Repeat proceeding, hence press NO.
Lock Programming
Î Press and hold Memory + Chase + Utility 1.
Î YES locks Programming, Backup and the function
MODIFY available within Preview Menu
Undo: Repeat proceeding, hence press NO.
Blank Chaser Storage indication
Î Press and hold Preview + Soft A + Soft B.
On display are the remaining steps to be programmed.
Upon release of the buttons, the desk returns to Top Menu.
Software Version
Î Hold both Soft Buttons, while turning on the desk.