MacDon M100 2009 - Page 33

OPERATOR’S STATION
Form 169304 33 Model Year - 2009
ENGINE RUNNING/HEADER ENGAGED
DRAPER HEADER/INDEX SWITCH OFF
(Scroll Through Display with CDM Switch or GSL Switch)
DISPLAY (Lower or Upper Line)
DESCRIPTION
#####.# ENGINE HRS
Total Engine Operating Time.
#####.# HEADER HRS
Total Header Operating Time.
##.# ACRES/HOUR
##.# HECTARES/HOUR
(If Metric)
Actual Cutting Rate In Acres (Hectares)/Hour.
###.# SUB ACRES
###.# SUB HECTARES
(If Metric)
Area Cut Since Last Reset.
###### TOTAL ACRES
###### TOTAL HECT
(If Metric)
Total Area Cut By Machine.
##.## REEL MPH
(Optional)
##.## REEL KPH (If Metric)
##.## REEL SENSOR
(If Sensor Disabled)
Reel Peripheral Speed.
##.# DRAPER SPEED
Draper Speed (0.0-10.0).
#### KNIFE SPEED
(Optional)
#### KNIFE SENSOR
(If Sensor Disabled)
Knife Speed In Strokes Per Minute.
##.# HEADER HEIGHT
##.# HEADER SENSOR
(If Sensor Disabled)
Distance Setting (00.0-10.0) Between Cutterbar &
Ground.
##.# HEADER ANGLE (Optional)
##.# HEADER SENSOR
(If Sensor Disabled)
Angle Setting (00.0-10.0) Header Relative To
Ground.
FUEL LEVEL |■■■■|■■■■|
Level of Fuel In Tank.
ENGINE TEMP ### ° F
ENGINE TEMP ### °C
(If Metric)
Engine Coolant Temperature.
##.# VOLTS
Engine Electrical System Operating Voltage.
SCROLL
(Lower Line)
Displays Sub-Menu After 2-3 Seconds.
(Scroll Through Sub-Menu Display with CDM Switch)
SCROLL SUB-MENU (Lower Line Only)
#### KNIFE SPEED
(Optional)
##.## REEL RPM
##.# DRAPER SPEED
FUEL LEVEL |■■■■|■■■■|
ENGINE TEMP ###
°
F
ENGINE TEMP ### °C
(If Metric)
##.# HEADER HEIGHT
KNIFE SPD OVERLOAD
(Lower Line)
Knife Speed Is Less Than Programmed Set-Point.