7-5
O w n e r ’ s M a n u a l
Automation
When this switch is engaged, the faders drop to the off po-
sition (all the way down), regardless of which fader bank
is selected.
BYPASS
FADERS
MUTES
AUTO TOUCH
FADER MOTORS
OFF
PAN
ALL
TRIM LEVELS
AUTOMATION
GROUP
GENERAL PLUG INS DIGITAL I/O
SAVE
SAVE AS... NEW
LOAD
SETUP
JOG & SHUTTLE
SHUTTLE
JOG
FAST FWD
STOP
PLAY
RECORD
All previously written automated fader
moves still play back when the fader mo-
tors are off, but the faders are disabled and
will not accept new dynamic automation
changes until the fader motors are turned
back on.
Writing Fader Moves
TO WRITE FADER MOVES
From the console:
1. Press the BYPASS button in the
Automation Section to engage the
automation functions.
2. Press the FADERS button to engage
Faders mode, if it’s not already lit. If
this is an initial automation pass, make
sure TRIM is off.
3. Press the PLAY transport control, or
press Play on the recorder, to initiate
timecode.
4. If you’re using Absolute Write mode
instead of AUTO TOUCH, make sure to
engage the WRITE button on the
channels that are to be automated.
5. At the desired times, move the
fader(s).
6. Upon completion of the automation
pass, if you’re satisfied with the
automated fader moves, make sure to
save the session (press SAVE in the
Setup Section).
TO WRITE FADER MOVES
From the screen:
1. Click on the Locator button in the
lower menu bar. The Locator window
appears on the screen.
2. Click on the BYPASS button to turn it
off and engage the automation
functions.
3. Click on the FADER button to engage
Faders mode, if it’s not already lit. If
this is an initial automation pass, make
sure TRIM is off.
To Next Page
Loading...
Need help?
General
