Mackie Digital 8 BUS User Manual

5-16
D i g i t a l 8 • B u s
Preparing for a Session
Looping Between Two Locate
Points
TO LOOP BETWEEN TWO LOCATE POINTS
From the console:
1. Create locate points at the starting
point and ending point of the desired
loop, as described previously.
2. Use the number buttons to type in the
two-digit locate number for the
starting point, and then press ENTER.
The number appears under FROM in
the RANGE display.
3. Press the LOOP button in the
Transport Section. Use the number
buttons to type in the two-digit locate
number for the ending point, and then
press ENTER. The number appears
under TO in the RANGE display.
4. Press the PLAY button in the
Transport Section. The recorder(s) will
play the section from the starting
point to the ending point, and will
continually repeat between these two
points until the STOP button is
pressed.
Note: Pressing PLAY when the POSITION
display indicates a time before the first
Loop point causes the transport to play
through to the second Loop point and then
begin repeating from then on. Pressing
play when the POSITION display indicates
a time after the second Loop point simply
causes the transport to play through to the
end of the tape/hard disk, etc. No looping
will occur.
TO LOOP BETWEEN TWO LOCATE POINTS
From the screen:
This function is only available from the
console.
SMPTE VIEW
SET TIME
MINUTESHOURS
SECONDS FRAMES
BARS BEATS LOOP
TICKS
POSITION
RANGE
MODE
FROM TO
2
3
4
5
7
1
6
8
9
0
ENTER
STORE
LOCATOR
LOOP
SNAPSHOT
JOG & SHUTTLE
SHUTTLE
JOG
REWIND
FAST FWD
STOP
PLAY
RECORD

Mackie Digital 8 BUS Specifications

General

Brand	Mackie
Model	Digital 8 BUS
Category	Music Mixer
Language	English