Magnetek flex 8ex - Changing Transmitter Batteries

Flex 8EX / 12EX EU System Instruction Manual
March 2018
Page 61 of 66
7.1.7 Changing Transmitter Batteries
Change the transmitter batteries by unscrewing the battery cover located on the
backside of the transmitter (see Fig. 30). During battery installation, make sure that the
blue ribbon is centered between the two batteries. After changing the batteries, also
make sure that all screws are tightened to avoid water, moisture, dirt, grease, or other
liquid penetration.
Fig. 30
1
2
↓