IMPULSE
®
•Link 5 Instruction Manual
April 2020
Page 15 of 47
4.4.2. Events
Events are used to view Run history, Fault history, and Alarm history of a drive. When an event is recorded,
the DLS4 will gather detailed information about the state of the drive.
The DataLogger Series 4 can log:
• 5000 Run events
• 400 Alarm events
• 400 Fault events
• Approximately 300 hours of monitor data (U01-01 – U01-12, plus up to 10 selectable monitors)
• 11 Parameter sets
The information for Runs, Alarms, and Faults can be viewed by selecting Events under the drive in the
Workspace tree.
Figure 7: Events
To Next Page
Loading...