16 Series, Model - 2816 4WD
ENGINE LUBRICATION
Service Specifications
Oil Level Check Interval ........................................................................ Daily.
Oil Change Interval .........................................Every 100 hours (See NOTE)
Oil Type ............................................... See Lubrication Table in this manual.
Oil Capacity — Without Filter Change .................... 3.7 Litre (3.9 QT)
With Filter Change ......................... 4.2 Litre (4.4 QT)
NOTE: Change the engine oil after the first 50 hours of operation and
then use the regular change interval. Change the engine oil more
frequently when the operating conditions are severe, such as, operating
under heavy load, starting and stopping with frequency, or operating in
very high or very low ambient temperatures.
Engine Oil Level
To check the engine oil level, put
the tractor on level ground and stop
the engine. Pull the dipstick out,
wipe the dipstick with a dry cloth
and install the dipstick to check the
oil level. If the oil level is below the
A(Add) Mark, add oil to raise the oil
level to the F(Full) Mark.
Do not raise the oil level above the
F(Full) Mark.
IMPORTANT : The level should be checked before starting of 5 minutes
after the engine has been shut off.
ENGINE OIL DIPSTICK
FULL MARK
ENGINE OIL DIPSTICK
ADD MARK
95
LUBRICATION/FILTERS/FLUIDS___________________________________________
To Next Page
Loading...
Need help?
General
