16 Series, Model - 2816 4WD
SPECIFICATIONS_______________________________________________________
Type ........................................................... Three Cylinder, Four Stroke Cycle,
Valve in Cylinder Head, Cross
Flow Porting
Firing Order....................................................................................1 — 3— 2
Bore
................................................................. 78mm (3.071 inch)
Stroke.
....................................................................92mm (3.622 inch)
Piston Displacement
.......................................................1318 cm
3
(80.43 Cubic inch)
Compression Ratio.........................................................................22.0 to 1
Governor Engine Speed Without Load............................... 2730 to 2780 RPM
Rated Engine Speed........................................................................ 2600 RPM
Engine Idle Speed................................................................. 950 to 1000 RPM
*Maximum Horsepower (Manufacturing Rating)
................................................................. 28HP at 2600 RPM
Valve Clearance (Intake and Exhaust Cold Engine)
.......................................................0.25mm (0.010 inch)
IMPORTANT:
Valve clearance adjustment must be made when the
engine is not running and is cold.
General
DIESEL ENGINE
Engine Lubrication System
Oil Pressure
....................................392kPa (57PSI) at 2500
Engine RPM with 10W–30 Oil
at 90°C (194°F)
Fuel System
Fuel Injection Pump.............................................BOSCH M Plunger In Line
NIPPONDENSO
Injection Pump Timing.
..................... 17 Degrees Before Top Dead Center (BTDC)
Fuel Injectors
. ..............Throttle Type, NIPPONDENSO
*Manufacturer’s estimate under standard condition and subject to change without prior notice.
20
To Next Page
Loading...
Need help?
General
