16 Series, Model - 2816 4WD
Rollover protection is provided only with proper assembly. Lock
pins, hinge pins and position pins must be in place. Correct parts
may be obtained from your dealer.
M234A
ROPS BAR
(NORMAL OPERATING POSITION)
LOCK PIN
POSITION PIN
JAM NUT
LOCK BOLT
LOCK NUT
STEP 18
STEP 17
Install the lock pins.
Install the lock nuts. Tighten the
nuts to a torque of 33 to 40 lb ft
(44 to 54 Nm).
NOTE: The lock nut installation
can be omitted for operator conve-
nience if the ROPS is folded
frequently.
LOCK NUT
LOCK PIN
19
SAFETY/DECALS_______________________________________________________
To Next Page
Loading...
