16 Series, Model - 2816 4WD
Engine can start with transmission in gear when neutral or safety
start switch is by-passed:
1. Do not connect across terminals on starter.
2. At
tach a booster battery by connecting the positive terminal of the
booster battery to the “positive terminal” provided or to the po-
sitive terminal of the machine battery. Connect the negative ter-
minal of the booster battery to the “negative terminal” provided or
to the chassis of the machine.
Th
en use recommended starting procedures from operators seat.
3. When necessary, repair electrical system components promptly
so that “jump starting” will not be attempted.
Machine run-away can cause injury or death to operator and bystan-
ders.
Make sure the fuel shut-off valve
is open. The valve is located at
the bottom RH side of the fuel
tank.
NORMAL STARTING PROCEDURE
IMPORTANT: It is very important that enough lubricant reaches the
en
gine parts before operating the engine at rated speed.
Operate controls only when seated in the operators seat.
Before starting the engine, be sure all operating controls are in
neutral or park lock position. This will eliminate accidental
movement of the machine or start up of power driven equipment.
Put the gear shift lever in the
Neutral position (Gear Drive)
M137
STEP 1
OPEN
FUEL SHUT-OFF VALVE
STEP 2
NEUTRAL POSITION
M106D
M107C
44
OPERATING INSTRUCTIONS
____________________________________________
To Next Page
Loading...
Need help?
General
