16 Series, Model - 2816 4WD
Turn the starter key switch to the
heat & ON position.
Wait until the glow plug indicator
lamp is put out.
(Approximately 1 to 3 seconds.)
Put the range shift lever in the N
(Engine start) slot.
Put the REAR PTO and MID
PTO control levers in the OFF
(Engine start) slot.
STEP 2
STEP 3
STEP 5
OFF POSITION
N SLOTS
HEAT
Put the engine speed control
lever at the low idle position.
STEP 4
STOP
45
OPERATING INSTRUCTIONS
____________________________________________
To Next Page
Loading...
