16 Series, Model - 2816 4WD
1. STARTER KEY SWITCH — The starter key switch can be removed
with the switch in the OFF position. Four
position switch as follows:
Engine and all lamps except
the turn signal and flasher
lamps are turned off.
First position clockwise from
OFF. In this position (Engine not
running) energizes the glow
plugs. The charge indicator, glow
plug indicator and oil pressure in-
dicator will illuminate.
The fu
el gauge and temperature ga
uge will show correct values.
OPERATING CONTROLS
Control Switches
position–
(OFF)
position–
(HEAT)
&
(ON)
position –
(START)
Turn the key fully clockwise against the force of the
spring in the switch. The starter motor will turn the
engine. Release the key immediately when engine
starts.
NOTE: To prevent operation by persons not authorized and the
possible discharge of the battery, remove the starter key when you leave
the tractor.
IMPORTANT: Do not keep the starter key switch in the ON position for
a lon
g period of time when the engine is not operating.
28
INSTRUMENTS /CONTROLS ______________________________________________
To Next Page
Loading...
