Mahindra ML170 series - Page 19

18
3.2.6. With hoist supporting Center Bracket
center bracket, install
16mm x 2.0P x 30mm
Grade 8.8 hex bolts
and 5/8" lockwashers,
2 places inside and
2 places outside
of bracket in front
area of cab.
Do not remove hoist.
16mm x 2.0P x 30mm Grade 8.8
Hex Bolt and 5/8" Lockwasher,
2 places inside (shown in illustration) and
2 places outside (shown in photo).
3.2.7. From rear axle, remove inside set of bolts and
lockwashers securing 3-point components to rear axle.
Save hardware.
Position of bolts to be removed
one on each side of axle.
3.2.8. Install rear rail to center bracket using 5/8" x
1-3/4" hex bolts Grade 5, lockwashers, and hex nuts,
2 places outside only.
Center Bracket
5/8" x 1-3/4" Hex Bolt Grade 5,
5/8" Lockwasher, and 5/8" Hex Nut.
2 places outside only.
Rear Rail