44
7.1.11. Slowly drive tractor forward while (E) retracting
tilt cylinders (F). Doing this will allow towers to guide
loader as it is being parked off of tractor. This will
allow loader to be held in position to clear exhaust
during dismounting.
7.1.12. Retract tilt cylinders (G) until bucket is level on
ground.
7.1.13. Make sure all loader components clear tractor.
Back tractor away (H) slightly.
7.1.14. Stop the tractor engine and then work valve
handle/handles to relieve hydraulic fluid pressure in
lines. Refer to tractor operator manual for additional
information.
7.1.15. Reinstall handle pins and snap pins to bearing
boxes for storage.
7.1.16. Return rubber strap to RH Cab hand rail for
storage.
7.1.17. Disconnect loader hoses from quick couplers.
7.1.18. Start tractor and slowly back tractor away from
the loader.
IMPORTANT: To avoid hydraulic hose damage, be alert and make sure hoses do not catch on tractor
and/or loader during mounting or dismounting.
WARNING: Make sure parked loader is on a hard level surface. Engage all safety devices to
prevent loader from falling and being damaged or injuring someone. Do not repair loader if it is
not mounted on the tractor. Loss of hydraulic fluid or removal of parts could cause loader to
collapse resulting in injury.
To Next Page
Loading...
Need help?
General