43
7.1.8. Make sure long end of parking stand is located
toward rear end of tractor. Photo shows parking
stands in park position and loader ready to be
dismounted.
Parking Stands in Park Position
with long end of stands
positioned rearward.
7.1.9. Retract tilt cylinders (A) to roll bucket back and
retract lift cylinders (B) to lower loader boom down
until parking stands make firm contact with ground.
NOTE: Driving the tractor forward slowly while
positioning loader will allow parking stands to
contact ground firmly.
Parking Stands
contacting ground firmly.
Bucket resting on ground.
7.1.10. Retract lift cylinders (C) until bearing box pins
(D) lift out of tower hooks and clear towers.
To Next Page
Loading...
Need help?
General