EasyManuals Logo

Makita LS1018-R Technical Information

Makita LS1018-R
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
P 33/ 45
Repair
[4] ADJUSTMENT
[4] -2. Adjustment
If there is a gap in the position circled in line, loosen M6x28
Hex bolt by turning a hex wrench counterclockwise.
If there is a gap in the position circled in line, tighten M6x28
Hex bolt by turning the wrench clockwise.
After adjustment, move Support arm
from side to side and confirm that
there is no gap.
Adjust on the opposite side
in the same way.
(1) Set blade to the lower dead point and fix it with Pin C.
(2) Remove Sub fence and Right sub fence.
(3) Set 1R207 in the position as shown below and adjust until the gap between blade and 1R207 is cleared.
(e.g.1) (e.g.2)
Fig. 128
Adjustment for 45° angle
2
Completed!
M6x28 Hex bolt M6x28 Hex bolt
Hex wrench Hex wrench
Gap
Gap
1R207
1R207
1R207

Other manuals for Makita LS1018-R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Makita LS1018-R and is the answer not in the manual?

Makita LS1018-R Specifications

General IconGeneral
BrandMakita
ModelLS1018-R
CategorySaw
LanguageEnglish

Related product manuals