35
EN
Fig. 27
A
B
Change the engine oil and the oil filter cartridge
every 6,000 km (3720 mi) or 12 months
• Warm the engine up for a few minutes, since the oil change
must be carried out while the engine is warm.
• Turn the engine off. Put an oil collecting pan under the engine
cover, in correspondence with the cap (A – fig. 27).
• Remove the filler cap and the dipstick, (A – fig. 26) and then
drain the oil.
• Clean the internal mesh by means of compressed air.
• Check the cap’s O-Ring conditions. Replace if necessary.
• Remove the cartridge oil filter with relevant O-Ring (B-fig.27)
and replace it.
• Before fitting the new cartridge filter, lubricate the relevant O-
Ring, and then tighten by hand.
• Reassemble the mesh and the oil filter cap with O-Ring.
• Top up the engine with oil and refit the filler cap with dipstick by
tightening it completely.
• Turn the engine on in order to fit the new filter cartridge and the
lubrication system. Turn the engine off and, after about 5 min-
utes, check the oil level and, if necessary, top up until it reaches
the MAX notch
NOTE: the oil cartridge filter must be replaced every time oil is
replaced, along with its gasket.
Every 3,000 km the message OIL is displayed on the dig-
ital dashboard. This warning light indicates that it is time
to change the engine oil.
This warning light is displayed on the dashboard until the
above-mentioned operation is carried out by an Author-
ised Malaguti Service Centre.
Used oil is toxic for the environment, therefore we sug-
gest you contact an Authorised Malaguti Service Centre
for oil disposal according to the rules in force.
To Next Page
Loading...
